Author Topic: Green Heron Enginerring RT-21  (Read 511 times)

Offline hk2ls

  • Remote Enthusiast
  • ***
  • Posts: 15
    • RN.ORG Website
Green Heron Enginerring RT-21
« on: December 26, 2017, 07:34:22 am »
Is there support for a Green Heron Engineering RT-21 (connected to a Yeasu G-1000)?  While I can control the rotor using GHMap.exe (connected on COM3 at 4800 baud) I can't seem to get RCForb Server to work with this.   Any ideas?
---
Larry Snyder, HK2LS

Offline w8rj

  • Moderator
  • Remote Master
  • *****
  • Posts: 2352
Re: Green Heron Enginerring RT-21
« Reply #1 on: December 26, 2017, 08:33:45 am »
Just a quick glance at the RT-21 controller indicates it's DCU1 compatible, so you should be able to select DCU1 with the proper baud rate (probably 4800) and it should work.
73
Roger
W8RJ

Offline ny4i

  • Remote Enthusiast
  • ***
  • Posts: 31
Re: Green Heron Enginerring RT-21
« Reply #2 on: January 03, 2018, 08:26:40 am »
If it helps, I can confirm this works as I am using an RT-21 on my club's system. DCU1 is the right protocol @ 4800 Baud.

Tom NY4I
Tom NY4I